41
Appendix
AM-4-035
1
2
3
4
1. Changing direction of rotation on cutting discs with quick-release blades
Disc mower AMT operating manual
Appendix for
•
The blades may continue to rotate after the drive has been switched off. Only
approach the mower once the working parts have come to a complete standstill.
•
Only carry out work on the mower unit once the PTO shaft has been switched off,
the engine switched off and the ignition key removed. Secure the tractor against
rolling away.
•
Safe operation is only guaranteed if the cutter blades are fitted according to the
instructions.
•
Always check the mower unit for damaged, missing or worn cutter blades before
operation. If necessary, replace cutter blades. The same applies for retaining
components.
•
To prevent unbalanced rotation, only replace missing or damaged cutter blades as
complete sets.
•
Never fit cutter blades with different levels of wear to one drum/disc.
•
Whenever you change cutter blades also check retaining components and replace
them if necessary.
TAKE NO RISKS!
Use only original KRONE parts!
Push the special tool (1) {blade key} between the cutter
disc (4) and leaf spring (3) and press down with one
hand. Guide blade (2) onto retaining bolt and allow the
blade key to return upwards.
2. Changing blades on cutter discs
with quick-release blades
HINWEIS
On the headstock is provided a support for the
knife replacement key (1).
NOTE
Summary of Contents for AMT 4000 CV
