38
Start-up after winter storage
7. Start-up after winter storage
Special safety notes
•
Repair, servicing, maintenance, cleaning work may only be carried out when the
machine is at a standstill. Switch off the machine. Remove the ignition key. Secure
the tractor from rolling away.
•
All protective plates and protective devices should be reassembled correctly after
servicing and maintenance work has been completed.
•
Prevent oil and grease coming into contact with the skin.
•
Contact a doctor immediately for injuries caused by escaping oil.
•
Observe all safety notes to prevent injuries and accidents.
7.1 General
•
Remove the grease and oils used to
preserve the machine
•
Carry out the measures given in the
chapter "Maintenance"
•
Ventilate the overload coupling
•
Carefully read through the operating
instructions again.
7.2 Overload coupling
CAUTION: The PTO shaft overload coupling should
be ventilated after extended standing periods. The
coupling plates may become stuck to the friction
plate
The overload coupling protects the tractor and the
machine from damage. It is fitted with a fixed starting
torque M
R
. The torque is stamped on the overload
coupling housing (2).
Ventilate the overload coupling
Tighten the four nuts (1). Block the machine and turn
the overload coupling by hand. Loosen the nuts again.
Alterations made to the overload coupling change
the starting torque. This results in the guarantee
becoming void!
Use only original KRONE parts!
NOTE
AMT-2-020
2
1
Summary of Contents for AMT 4000 CV
