6
KRATOS SAFETY certifies that the anchor point has been tested in accordance with the standard EN 795:2012 Type A.
COMPATIBILITY FOR USE:
An anchorage point must be used in a fall arrest system as defined in the product’s factsheet (see RN 363) in order to guarantee a maximum arrest force
of 6 kN on the user. A fall arrester harness (EN361) is the only body support device permitted for use. It may be dangerous to create your own fall arrest
system in which each safety function may interfere with another safety function. As such, before each use, refer to the recommendations for use for each
of the system’s components.
INSPECTIONS:
The recommended service life of this product is unlimited (in accordance with the annual examination by a competent person authorised by KRATOS
SAFETY), but it may be reduced according to use and/or the results of the annual inspections.
The equipment should be inspected if there is any doubt, or following a fall, and at least annually, by the manufacturer or a competent person* and in
strict compliance with the manufacturer’s periodic inspection procedures (and in particular the inspection guides ref. GI XX-XXXXXX-XX) to check
its strength and therefore the user’s safety. The results of the periodic inspection must be recorded in the ENTECH01 inspection report (downloadable
from our website). We recommend that routine inspections are documented using an inspection report and photographs.
*: refer to the definition of a competent person on our website under: Info/Technical Advice
The “Equipment identification sheet” should be completed (by writing) after each verification; date of inspection and date of next inspection must be
indicated on the “Equipment identification sheet”, it is also recommended to put date of next inspection on the product.
MAINTENANCE AND STORAGE:
(these instructions must be strictly observed)
No particular servicing
Summary of Contents for FA 60 014 00
Page 35: ...35...
Page 36: ...36 NOTES...
