Kramer Electronics Ltd.
VS-88H2A
– Connecting VS-88H2A
9
Connecting Output to a Balanced/Unbalanced Stereo Audio Acceptor
5. If required, connect:
▪
The 5V/2A USB port
to the USB port of another device to charge it.
▪
The ETHERNET port
to a control device.
▪
The RS-232 port
to a control device (not shown in
).
6. Connect the power cord to the power connector
and to the mains electricity (not
).
We recommend that you use only the power cord that is supplied with this machine.
Connecting Output to a Balanced/Unbalanced Stereo
Audio Acceptor
The following are the pinouts for connecting the output to a balanced or unbalanced stereo
audio acceptor:
Figure 4: Connecting to a Balanced Stereo Audio
Acceptor
Figure 5: Connecting to an Unbalanced Stereo Audio
Acceptor
Connecting to VS-88H2A via RS-232
You can connect to
VS-88H2A
via an RS-232 connection
using, for example, a PC.
VS-88H2A
features an RS-232 3-pin terminal block connector allowing the RS-232 to control
VS-88H2A
.
Connect the RS-232 terminal block on the rear panel of
VS-88H2A
to
a PC/controller, as
follows:
From the RS-232 9-pin D-sub serial port connect:
•
Pin 2 to the TX pin on the
VS-88H2A
RS-232 terminal
block
•
Pin 3 to the RX pin on the
VS-88H2A
RS-232 terminal
block
•
Pin 5 to the G pin on the
VS-88H2A
RS-232 terminal block
RS-232 Device
VS-88H2A
18
20
22
23
22