Kramer Electronics Ltd.
VS-88H2A
– Operating VS-88H2A via Front Panel Buttons
21
To route an HDMI OUT ARC to an HDMI input port:
1. Press
D-AUDIO
and
A-AUDIO
simultaneously.
Both buttons illuminate and the device enters the ARC routing mode (for example, HDMI
OUT 1, 2, 3 and 4 are enabled).
2. Press
D-AUDIO
until it flashes.
The out HDMI ARC-enabled outputs illuminate, as before.
The ARC-enabled inputs flash (for example, 1, 5 and 7 are ARC enabled, 3 is illuminated
therefore not enabled).
On the front panel button:
•
Output button is not illuminated.
•
An illuminated input button means that it is a disabled ARC input.
•
A flashing input button means that it is ARC-enabled.
On the 7-segment display:
•
“
.
” under an output number indicates that arc is enabled on the corresponding output
(outputs 1 to 4 in this example).
•
“
A
” under an output number indicates that an analog audio input is routed to that
output.
•
“
d
” under an output number indicates that the embedded audio is routed to that
output.
•
“
0
” under an output number indicates that the audio output is muted.
3. Press an ARC enabled input button (for example IN 5) to select the destination port.
The corresponding 7-segment display LED flashes.
4. Press an output button (for example OUT 8) to select the HDMI audio output that will be
routed to the input.
The flashing 7-segment display LED shows the selected input number and
after selecting the HDMI audio OUT the port number appears (8).
An HDMI audio output is routed to an HDMI ARC input port.
Routing Analog Audio Inputs to HDMI Input Ports
To route an analog audio input to an HDMI input, enable ARC on the HDMI input ports and
then route them.
To set an HDMI input to ARC mode:
ARC can be enabled or disabled at any time, regardless of whether an amplifier is
connected to the HDMI input or not.
Inputs can be set either to the Step-in mode or the ARC mode.
1. Press and hold
EDID
and
ALL
simultaneously until both buttons illuminate and the
device enters ARC mode: