16
VS-611DT - Operating the VS-611DT
5.11 Upgrading the Firmware
The
VS-611DT
can be upgraded via USB or RS-232.
For instructions on upgrading the firmware, see “
K-Upload Software
User Guide
”
(
www.kramerav.com/support/download.asp?f=39700
).
5.12 Step-In Support
The
VS-611DT
supports programmable step-in functionality when used in
conjunction with compatible step-in devices, such as the
SID-X3N
and
DIP-31
(using an HDMI cable that supports HEC, the HDMI Ethernet Channel).
When ARC mode is enabled, Input 1 step-in mode is disabled. If you require step-in
mode on Input 1, set the audio output to the device inputs (see
Section 6.1
).
5.13 Controlling the VS-611DT via the Terminal Block
Connector
The INPUT SELECT terminal block connector includes six input pins and a G pin
for selecting an input.
The contact closure remote control pins operate in a similar way to the input buttons
(see
Section 5.1.1
). Using the contact closure remote control (also known as push-
to-make momentary contact) you can select any of the inputs. To do so,
momentarily connect the required input pin (1 to 6) to the G (ground) pin of the
INPUT SELECT terminal block connector, as
Figure 3
illustrates.
Do not
connect more than one input pin to the G pin at the same time.
Figure 3: Connecting the Contact Closure Remote Control Pins
Summary of Contents for VS-611DT
Page 1: ...USER MANUAL MODEL VS 611DT UHD 6x1 2 Auto Switcher P N 2900 300464 Rev 3 www kramerAV com...
Page 2: ......
Page 3: ......
Page 4: ......
