![background image](http://html1.mh-extra.com/html/kramer/vs-611dt/vs-611dt_user-manual_2002334018.webp)
VS-611DT – Operating the VS-611DT
13
To copy the EDID from the HDBT output:
1. Press the EDID button to cycle through the EDID sources until all front panel
LEDs flash twice, indicating that the EDID is copied from HDBT.
2. Press the button of the input that receives the EDID.
3. Press and hold EDID for 5 seconds to copy.
To copy the default EDID:
1. Press the EDID button to cycle through the EDID sources until all front panel
LEDs flash three times, indicating that the default EDID is copied
2. Press the button of the input that receives the EDID.
3. Press EDID and hold for 5 sec to copy.
5.6
Setting the 5V Output Time Delay
When there is no signal clock or 5V input on all inputs for 15 minutes, the device
shuts down the 5V output. This enables output devices such as projectors or
displays to go to sleep. The 15 minute default time delay can be changed to 5
minutes or 10 minutes using the Auto Sync Off feature on the Device Settings Web
page (see
Section 6.3
).
5.7
Setting HDCP Capability
Each input can be individually set to HDCP support on or off.
To set HDCP support:
1. Disconnect device power.
2. Press and hold the Lock button while reconnecting device power.
The Lock LED flashes indicating HDCP setup mode.
3. Press the Input 1-6 button(s) to set HDCP.
4. If the LED is on, HDCP passes to the port.
If flashing, HDCP does not.
Summary of Contents for VS-611DT
Page 1: ...USER MANUAL MODEL VS 611DT UHD 6x1 2 Auto Switcher P N 2900 300464 Rev 3 www kramerAV com...
Page 2: ......
Page 3: ......
Page 4: ......