30
VS-611DT - Protocol 3000
All the examples provided in this section are based on using the
K-Config software.
You can enter commands directly using terminal communication software (e.g.,
Hercules) by connecting a PC to the serial, Ethernet or the USB (VCOM) port on
the
VS-611DT
. To enter
CR
press the Enter key (
LF
is also sent but is ignored by
the command parser).
Commands sent from various non-Kramer controllers (e.g., Crestron) may require
special coding for some characters (such as,
/X##
). For more information, refer to
your controller’s documentation.
For more information about:
•
Using Protocol 3000 commands, see
Section 10.1
•
General syntax used for Protocol 3000 commands, see
Section 10.2
•
Protocol 3000 commands available for the
VS-611DT
, see
Section 10.3
10.1 Understanding Protocol 3000
Protocol 3000 commands are structured according to the following:
•
Command –
A sequence of ASCII letters (
A-Z
,
a-z
and
-
). A command and
its parameters must be separated by at least one space.
•
Parameters –
A sequence of alphanumeric ASCII characters (
0-9
,
A-Z
,
a-z
and some special characters for specific commands). Parameters are
separated by commas.
•
Message string –
Every command entered as part of a message string begins
with a message starting character and ends with a message closing character.
A string can contain more than one command. Commands are
separated by a pipe (
|
) character. The maximum string length is 64
characters.
Summary of Contents for VS-611DT
Page 1: ...USER MANUAL MODEL VS 611DT UHD 6x1 2 Auto Switcher P N 2900 300464 Rev 3 www kramerAV com...
Page 2: ......
Page 3: ......
Page 4: ......
