Kramer VS-611DT, User Manual

Page: 5 / 54

VS-611DT – Contents i
Contents
1 Introduction 1
2 Getting Started 2
2.1 Achieving the Best Performance 2
2.2 Safety Instructions 2
2.3 Recycling Kramer Products 3
3 Overview 4
3.1 About Fast Switching 5
3.2 Defining the VS-611DT UHD 6x1:2 Auto Switcher 6
4 Connecting the VS-611DT 8
4.1 Connecting a Serial Controller to the VS-611DT via RS-232 9
5 Operating the VS-611DT 10
5.1 Switching – Manual and Auto 10
5.2 Performing a Factory Reset 11
5.3 Locking the Front Panel Buttons 12
5.4 Turning the Output Off 12
5.5 Copying the EDID 12
5.6 Setting the 5V Output Time Delay 13
5.7 Setting HDCP Capability 13
5.8 Setting the Audio Output 14
5.9 Setting the Switching Speed 15
5.10 Using VCOM on USB 15
5.11 Upgrading the Firmware 16
5.12 Step-In Support 16
5.13 Controlling the VS-611DT via the Terminal Block Connector 16
6 Using the Web Pages 17
6.1 Routing Inputs to Outputs 17
6.2 Using EDID Settings 19
6.3 Setting Device ID Parameters 21
6.4 Contacting Kramer 22
7 Technical Specifications 23
8 Supported Resolutions 24
9 Default Settings 26
9.1 Default Communication Settings 26
9.2 First Power On Default Settings 26
9.3 Default EDID 27
10 Protocol 3000 29
10.1 Understanding Protocol 3000 30
10.2 Kramer Protocol 3000 Syntax 31
10.3 Protocol 3000 Commands 33
Figures
Figure 1: VS-611DT UHD 6x1:2 Auto Switcher 6
Figure 2: Connecting the VS-611DT UHD 6x1:2 Auto Switcher 9
Figure 3: Connecting the Contact Closure Remote Control Pins 16