©
KRAMER ELECTRONICS LTD.
Issue 1-16 May 30, 2017
39
6.2.3
Output Config
6.2.3.1
HDMI & DVI Outputs
Internally, the output interface processes data at a full ten bits per colour. The colour depth on the
HDMI outputs is determined by the supported standard of the attached monitor or device when set to
DVI/HDMI.
DVI 1.0 and HDMI 1.1/1.2 devices are set at 24 bit, for HDMI 1.3 or later compliant devices it is up to 36
bit. The DVI forced selection will output video with 24 bit colour depth irrespective of the supported
standard of the attached monitor.
Settings:
DVI forced, DVI/HDMI, HDMI 8-bit, 10-bit, 12-bit
Default :
HDMI
6.2.3.2
HDCP
HDCP encryption support on the output can be switched off as is in the input. This means the unit
pretends to be non-HDCP compliant on the DVI/HDMI output port and consequently does not encrypt
data.
At the same time, HDCP is also turned off at the input ports. This allows the unit to accept non-HDCP
encrypted data. If the source however, is HDCP encrypted, then the output will be black.
Settings:
On, Off
Default :
On
6.2.3.3
DVI Colour Space
This menu allows users to select between the RGB and YPbPr colour spaces
Settings:
RGB, YPbPr
Default:
RGB
6.2.3.4
DVI Range
When set to Default CEA, the output modes have limited range, and VESA modes have full range.
Therefore, an incoming limited range mode is either passed through when the output is set to a CEA
output mode or expanded when the output is set to a VESA mode. An incoming full range mode is
either compressed when the output is set to a CEA output mode or passed through when the output
is set to a VESA mode.
If the HDMI/DVI output does not operate properly, the range can be changed manually. A limited
video range is only using the following greyscale for video information - 8 Bit System: 0x10 .. 0xEF, 10
Bit System: 0x040 .. 0x03BF, 12 Bit System: 0x100 .. 0xEFF.
Settings :
Default, Limited, and Full
Default :
Full
