Kramer VP-771, User Manual

Page: 43 / 77

38 VP-771 - The OSD Menu
Setting Function
Information Displays the input resolution and frequency, the output resolution and
firmware versions M / P
If the selected output is the native output resolution, it will be displayed under
"Native Output:"; in case of an explicit output resolution the title will be "Output:"
If the stream is encrypted, an HDCP icon appears next to the input information
OSD Set:
Window Control – to Main Window Control to set the OSD menu to
control the Main window (letting you select the input and other parameters
for the main window) or to PiP Window Control to control the PiP window
(letting you select the input and other parameters for the PiP window) E
H Position – to set the horizontal position of the OSD E
V Position – to set the vertical position of the OSD E
Transparency – to set the transparency to On or Off E
Transparency Gain – to set the transparency level (once set to
transparent) E
Transparency Bias
– to set the transparency level
E
Blink – to On for the selected item in the OSD to blink, or Off E
Blink Period – to determine the blinking rate E
Timeout – to 30 seconds before OSD timeout, 60 seconds before OSD
timeout or OFF (Off means that that the OSD appears continuously) E
Advanced Set:
V Keystone – to set the vertical keystone level E
Useful If the projector is located at an angle above or below the screen. In the
OSD menu the value range shows -80 to 80. This feature is disabled on
interlaced input
Auto Sync Off – to turn the auto sync On/Off.
When ON, 2 minutes after not detecting a valid video signal on the
selected input (or both inputs in the dual window mode), the unit will
disable the syncs and the audio on all the outputs, until a valid input is
again detected or any keypad button is pressed to activate the machine
(once restored, the buttons return to their normal function) E
When using the VP-771 for audio only, we recommend that
you turn this feature off
Luma Keying – to set the transparency level of the PIP window (see
Section 6.8.1 ) E
Volatile parameter; screen may flicker
Pause Set:
Freeze – to ON to freeze the window (freezing the main window will also
mute the audio output)
M
/
P
Blank – to ON to display a blank window (blanking the main window will
also mute the audio output) M / P
Note that any change in the display mode, the input
source and/or the output resolution may cancel the freeze
and blank settings.
Mute – to ON to mute the audio output E
A mute icon appears on screen
Disable Output – to turn the sync and audio On/Off.
When ON, the unit will disable the syncs and mute the audio output until
any keypad button is pressed E
Pause
continued
Once Disable Output is enabled, a countdown appears, letting you cancel
the process and revert to the previous state
i
i