Kramer VP-771, User Manual

Page: 32 / 77

VP-771 - The OSD Menu 27
27
Setting Function
Embedded Set:
Pass-through – to On to pass the digital audio input directly to the output
without any processing or set to Off to process the digital audio input E
Note that this feature is disabled for the non-embedded audio
inputs (PC, CV, YUV).
In case the audio signal is encrypted or compressed, we
recommend that you set Pass-through to On although it might
not have the capacity to transmit the audio without loss.
Analog Takeover – to On for the analog inputs of the HDMI and DP inputs
to take over the embedded inputs; select Off to use the embedded inputs E
Analog takeover is available only if an unbalanced audio signal is connected
(via 3.5mm connecter). When set to On, the embedded audio is disabled as
long as the 3.5mm cable is connected to the 3.5mm mini jack
Delay Set:
Lip Sync delay value [msec] E
Mic Delay value [msec] E
Power
Amplifier
Set the power amplifier (SPKR) level to Off or to levels 1 to 4 E
This submenu item is specific for the power amplifier, on top of the general volume
level
Note that if the power amplifier overheats, a warning appears
on the screen requesting to reduce the power level or volume. If
overheating persists, a shutdown warning appears and the
power amplifier shuts down for 30 seconds and then turns on
again
SDI
Channeling
Set the SDI channeling for groups A, B, C and D and connect the active and
the bypassed channels (see Section 6.3.1 )
By default, groups A and B are connected and groups C and D are disconnected
Set the SDI channeling for groups A, B, C and D to Activate CH1, Activate
CH2 or Bypass. If other groups are set to Activate or Bypass, the remaining
groups are read as None
Figure 15: Set the Output Volume Level
i
i