NCL-195 REMOTE CONTROL INFORMATION
PAGE 29
INITIAL SET-UP:
NOTE: This system is sent to you set up for Natural Gas and
temperature units readable in Fahrenheit.
CONTINUOUS PILOT FEATURE:
Activation of this optional feature is accomplished by pressing
PILOT
button
once. The continuous pilot icon will appear on the LCD screen.
Pressing
PILOT
button again will de-activate this feature.
This feature can also be activated via
CONTINUOUS PILOT
switch on Main
Control Module.
CHILDPROOF FEATURE:
Activation of this optional feature is accomplished by pushing
SET & UP
buttons simultaneously for 5 seconds. The childproof icon will appear on the
screen. When a transmitter button is pressed the icon will flash on screen, but no
signal will be transmitted. Pressing and holding these same two buttons again
for more than 5 seconds will de-activate this function.
This feature controls only manual functions of the hand held remote, automatic
functions (thermostat mode) will not be effected.
CELSIUS/FAHRENHEIT CONVERSION:
GAS TYPE CONVERSION:
Press and hold
Learn
Button
on Main Control Module for 20 seconds. A beep will be heard letting you know the procedure has been
completed.
If converting from NAT to LP gas:
(1) one second long beep
If converting from LP to Nat gas:
(3) three second long beep
Continue with gas type conversion by following instructions included with gas conversion kit.
Press
UP
and
DOWN
keys simultaneously to choose Celsius or Fahrenheit.
This system allows for gas type conversion and temperature unit conversion by following the setup procedure outlined below.
This system has a maximum room temperature limit of 95° F (35° C) in both manual and thermostat modes. When room temperature is at or
above this point the system will shut down and the hand held remote control will read
OFF
. If you turn the system
ON
when room temperature
is still at or above this temperature, the system will again shutdown after 2 minutes when room temperature is recalculated.
IMPORTANT SAFETY FEATURE:
Plug Extension Module
and
AC Adaptor
into receptacles.
Install (4) AAA batteries into battery compartment of
Backup Battery Pack
, making sure batteries are installed in proper direction.
Position between valve and front of stove. A Velcro strip has been attached to help secure in place.
The
Hand Held Remote
operates on (2) 1.5V AAA batteries. We recommend always using ALKALINE batteries to extend battery life and
improve operational performance.
.
Summary of Contents for Nicollet NCL-195
Page 43: ...PAGE 42...
Page 44: ...PAGE 43...
