Kospel HPMI2 - 12, Installation And Operating Instructions Manual

Page: 45 / 48

Heat pump HPM2.Z Kospel Sp. z o.o. start-up card
Start-up date
Assembly address
Installer's data
Stamp
Data
Outdoor unit no. Indoor unit no. C.MI2 module no.
Data of additional devices
Type of plate exchanger DHW cylinder type Buffer CH type
Heating system* Floor heating Radiators Mixed system
Heating system filled* Drinking water
Treated water +
corrosion inhibitor
Glycol solution
propylene
Checking activities outside*
Outdoor unit:
Installed without restriction of air supply YES NO
On a pedestal (stand) YES NO
Mounted vibro-isolators YES NO
Condensate is drained
(infiltration at the level below freezing)
YES NO
Condensate discharge to the gutter - siphoned pipe, insulated,
preferably with a heating cable
YES NO
Hydraulic connection made with a flexible hose
YES NO
Power and communication cable connected YES NO
The outside temperature sensor is placed on the wall
(according to the instructions)
YES NO
Checking activities inside*
Internal temperature sensor placed in the room representative
YES
NO
YES
NO
YES NO
Valves with discharge and bypass, pipes with a slight slope were
installed (to drain the water from the outdoor unit when necessary)
YES
NO
ZA thing at input FN1 has been installed
- deactivation of the device operation lock
YES
NO
Enter the values for the pressure and flow rate of the refrigerant
in the heating circuit after commissioning
pressure (bar)
flow rate (l/min)
*cross out unnecessary
Certificate no.
Internet module C.MI2 connected and configured
(according to the instructions)
A desilter filter is installed at the pump inlet