Chapter 5 Management Page 19
network settings.
Subnet Mask:
This is the subnet mask address for your bridge device. Set the IP subnet mask
manually.
Default Gateway:
Set the default gateway IP address manually.
DNS 1 & 2:
The Domain Name System (DNS) is how the Internet translates domain or website
names into Internet addresses or URLs. Your ISP will provide you with at least one DNS Server IP
Address. If you wish to use another, enter that IP Address in
DNS 2
field.
Router Mode - WAN/LAN Setup
When configured the System Operation Mode to Router mode, the Web interface shows below 2
new configuration fields.
WAN Setup:
The page allows you to configure the IP Address, Subnet Mask, Default Gateway
and DNS 1/2 for the WAN Port. While the WAN Port is
Ethernet
port, the settings will be applied
to the Ethernet RJ-45 port.
Note:
If your PC is not located within the same IP subnet of the WAN port, please remember to
modify your PC’s IP address to re-connect the AP.
LAN Setup:
The page allows you to change the IP address, Subnet Mask for the LAN.
Click
Apply
after configured the new settings. The new settings are activated immediately after
you applied.
Spanning Tree Protocol
The Spanning Tree Protocol (STP) is a network protocol that ensures a loop-free topology for any
bridged Ethernet local area network. The basic function of STP is to prevent bridge loops and
ensuing broadcast radiation. Spanning tree also allows a network design to include spare
