9
2.8 Wiring RS-232 Console Cable
JetNet 5020G attached one RS-232 DB-9 to RJ-45 cable in the unit box. Connect the
RJ-45 connector to the COM port of your PC, open Terminal tool and set up serial settings
to 9600, N,8,1. (Baud Rate: 9600 / Parity: None / Data Bit: 8 / Stop Bit: 1) Then you can
access CLI interface by console able.
Note: If you lost the cable, please contact with your sales or follow the pin assignment to
buy a new one. The Pin assignment spec is listed in the appendix.
2.9 DIN-Rail Mounting Installation
The DIN-Rail clip has been attached to JetNet 5020G mainframe in production. If the
DIN-Rail clip is not screwed on JetNet 5020G, follow the instructions and the figure below
to attach DIN-Rail clip to the device.
1.
Use the screws to attach DIN-Rail clip to the real panel of JetNet Din Rail Switch.
2.
To remove DIN-Rail clip, reverse step 1.
