122
System Event
Warning Event is sent when…..
Device Cold Start
Power is cut off and then reconnected.
Device Warm Start
Reboot the device by CLI or Web UI.
Authentication failure
An incorrect password, SNMP Community String is
entered
.
Time Synchronize
Failure
Accessing to NTP Server is failure.
Ring
If ring topology changed
Ping Reset
Ping target device and trigger relay to emulate power
reset for remote device, if remote system crash. Note:
once perform Ping reset, the relay output will form a
short circuit.
Dry Output
Relay continuous perform On/Off behavior with
different duration.
Port Event
Warning Event is sent when…..
Link-Up
The port is connected to another device
Link-Down
The port is disconnected (e.g. the cable is pulled out,
or the opposing devices turns down)
Once you finish configuring the settings, click on
Apply
to apply your configuration.
4.11.3
SysLog Configuration
System Log is useful to provide system administrator locally or remotely monitor switch
events history. There are 2 System Log modes provided by JetNet 5020G, local mode and
remote mode.
Local Mode
: In this mode, JetNet 5020G will print the occurred events selected in the
Event Selection page to System Log table of JetNet 5020G. You can monitor the system
logs in [Monitor and Diag] / [Event Log] page.
Remote
Mode
: The remote mode is also known as Server mode in JetNet 5020G. In this
mode, you should assign the IP address of the System Log server. JetNet 5020GG will
send the occurred events selected in Event Selection page to System Log server you
assigned.
Both:
Above 2 modes can be enabled at the same time.
Once you finish configuring the settings, click on
Apply
to apply your configuration.
Note:
When enabling Local or Both mode, you can monitor the system logs in [Monitor and
Diag] / [Event Log] page.
