TIGW1U server—Server Installations and Upgrades
Kontron Carrier Grade Server TIGW1U
Product Guide, rev. 1.3
December 2009
56
6. Connect the fan cable to the connector on the SFP board.
3.5.3
Replacing the SAS Front Panel Board
The SAS Front Panel (SFP) board provides an interface to the controls at the front of
the system, the power interconnect for the server board, the USB2 and Serial B
interface, and the front panel LED interface connections. It also houses the optional
hardware RAID5 components and optional SMART Embedded USB Solid-State Drive.
Caution:
When handling this board, observe safety and ESD precautions. (See
Appendix A,
“Safety Information”
for more information.)
To replace the SFP board, the following components must be removed:
• All cable connections on the SFP board and selected connections from other board
components
• PCI fan assembly and air duct
• CPU four-fan assembly and air duct
• LED light pipes to the front panel
Caution:
Before replacing any of the TIGW1U server boards, you must first take the server out of
service, turn off all peripheral devices connected to the system, turn off the system by
pressing the power button, and unplug the power cord from the system or wall outlet.
3.5.3.1
Removing the SAS Front Panel (SFP) Board
1. Power down the server system and unplug all peripheral devices and the power
cable.
2. Remove the chassis cover.
3. Remove the PCI fan assembly, including the bracket and air duct.
4. Remove the CPU four-fan assembly, including the bracket and air duct.
Figure 45.
Installing the PCI Fan into the Bracket
TS000296