CP605
Phoenix BIOS
ID 25095, Rev. 07
© 2004 Kontron Modular Computers GmbH
Page 5 - 37
2509
5.07.UG.VC.041005/14230
4
Invalid System Configuration Data
Problem with NVRAM (CMOS) data.
I/O device IRQ conflict
I/O device IRQ conflict error.
PS/2 Mouse Boot Summary Screen:
PS/2 Mouse installed.
nnnn kB Extended RAM Passed
Where
:
<nnnn>
is the amount of RAM in kilobytes successfully tested.
nnnn Cache SRAM Passed
Where
:
<nnnn>
is the amount of system cache in kilobytes successfully tested.
nnnn kB Shadow RAM Passed
Where
:
<nnnn>
is the amount of shadow RAM in kilobytes successfully tested.
nnnn kB System RAM Passed
Where: <nnnn>
is the amount of system RAM in kilobytes successfully tested.
One or more I2O Block Storage Devices were excluded from the Setup Boot Menu
There was not enough room in the IPL table to display all installed I2O block-storage devices.
Operating system not found
Operating system cannot be located on either drive A: or drive C:. Enter Setup and see if fixed
disk and drive A: are properly identified.
*Parity Check 1 nnnn
Parity error found in the system bus. BIOS attempts to locate the address and display it on the
screen. If it cannot locate the address, it displays: ????. Parity is a method for checking errors
in binary data. A parity error indicates that some data has been corrupted.
*Parity Check 2 nnnn
Parity error found in the I/O bus. BIOS attempts to locate the address and display it on the
screen. If it cannot locate the address, it displays ????.
