Phoenix BIOS
CP605
Page 5 - 8
© 2004 Kontron Modular Computers GmbH
ID 25095, Rev. 07
2509
5.07.UG.VC.041005/14230
4
There is one IDE connector for each adapter on your machine, usually labeled "Primary IDE"
and "Secondary IDE." There are usually two connectors on each ribbon cable attached to each
IDE connector. In a two drive configuration, the order of placement of Device 0 and Device 1
on the ATA interface cable is not significant to the operation of the interface. If only a single
device is attached via the ATA interface to a host, it is recommended that the host and the de-
vice be placed at the two ends of the cable.
If you need to change your drive settings, selecting one of the Master or Slave drives on the
Main Menu displays a sub-menu, as follows:
Figure 5-3: Master/Slave Sub-Menu — Screen Display
Use the legend keys listed on the bottom to make your selections and exit to the Main Menu.
Use the following chart to configure the hard disk.
PhoenixBIOS Setup Utility
Main
Primary Master
Item Specific Help
Type: [User]
Cylinders: [ 13328]
Heads: [ 15]
Sectors [ 63]
Maximum Capacity: 6449 MB
Total Sectors 40031712
Maximum Capacity 20496MB
Multi Sector Transfer; [16 Sectors]
LBA Mode Control: [Enabled]
32-bit I/O: [Enabled]
Transfer Mode: [Fast PIO 4]
Ultra DMA Mode [Enabled]
Select the drive type
of the fixed disk
installed in your sys-
tem. If type User is
selected, Cylinders,
Heads, and Sectors can
be edited directly.
Auto attempts to auto-
matically detect the
drive type for drives
that comply with ANSI
specifications.
F1 Help
Select Item -/+ Change Values F9 Setup Defaults
ESC Exit
Select Menu Enter Select Sub-Menu F10 Save and Exit
