D R A F T — F O R I N
T E R N A L U S E O N L Y
92
www.kontron.com
User Guide
CP3004-SA
11.4.5 XMC Module Installation
The 8 HP CP3004-SA equipped with the CP3004-XMC module provides an XMC connector, J1, for con-
nection to an XMC module such as the Kontron XMC 401, XMC402, etc.
The XMC module must be installed on the CP3004-XMC prior to installation of the CP3004-SA with the
CP3004-XMC in a system.
Before installing an XMC module on the CP3004-SA equipped with an CP3004-XMC extension module,
ensure that the safety requirements indicated in section 11.1 are observed.
Note:
Failure to comply with the instruction below may cause damage to the board or result in
improper system operation.
To install an XMC module on the CP3004-SA equipped with an CP3004-XMC extension module, refer to
the figures shown below and proceed as follows:
Figure 31: Screws Securing the Front Panel and the CP3004-XMC to the CP3004-SA
(h)
(g)
(j)
(i)
(c)
(b)
(e)
(f)
(d)
(a)
J1
