D R A F T — F O R I N
T E R N A L U S E O N L Y
21
www.kontron.com
User Guide
CP3004-SA
1.5 Standards
This product complies with the requirements of the following standards.
Note:
Customers desiring to perform further environmental testing of the CP3004-SA must con-
tact Kontron for assistance prior to performing any such testing.
Boards
without conformal coating
must not be exposed to a change of temperature which
can lead to condensation, as it may cause irreversible damage especially when the board
is powered up again.
Kontron does not accept any responsibility for damage to products resulting from destruc-
tive environmental testing.
Table 2: Standards
TYPE
ASPECT
STANDARD
REMARKS
CE
Emission
EN55022, EN61000-6-3
For information about the PCI clock
instructions, refer to section 2.7.8.1.
Immunity
EN55024, EN61000-6-2
--
Electrical Safety
EN60950-1
--
Mechanical
Mechanical Dimensions IEEE 1101.10
--
Environmental Climatic Humidity
IEC60068-2-78 (see note below)
--
WEEE
Directive 2002/96/EC
Waste electrical and electronic equip-
ment
RoHS 2
Directive 2011/65/EU
Restriction of the use of certain haz-
ardous substances in electrical and
electronic equipment
Vibration
(Sinusoidal)
IEC60068-2-6
Test parameters:
10-300 (Hz) frequency range
5 (g) acceleration
1 (oct/min) sweep rate
10 cycles/axis
3 axes
Single Shock
IEC60068-2-27
Test parameters:
30 (g) acceleration
9 (ms) shock duration half sine
3 number of shocks per direction
(total: 18)
6 directions
5 (s) recovery time
Bump Shock
IEC60068-2-29
Test parameters:
15 (g) acceleration
11 (ms) shock duration half sine
500 number of shocks per direction
6 directions
5 (s) recovery time
