D R A F T — F O R I N
T E R N A L U S E O N L Y
96
www.kontron.com
User Guide
CP3004-SA
11.4.7 Rear I/O Device Installation
The CP-RIO3-04 rear transition module does not support hot swapping. Therefore, the system must
have power removed to install or remove the CP-RIO3-04 rear transition module. Before extracting the
CP-RIO3-04 rear transition module, ensure that all connected cables are disconnected. For physical in-
stallation of rear I/O devices, refer to the documentation provided with the device itself.
Note:
VGA and Ethernet can be used either on the front panel or on the rear I/O. COMA can be
used either on the 8 HP extension module or on the rear I/O. It is not possible to use any
of the above-mentioned interfaces on the front or the 8 HP extension and on the rear I/O
simultaneously.
11.5 Batter y Replacement
The CP3004-SA RTC may be backed up using a single 3.0 V “coin cell” lithium battery from one of two
possible points of installation:
»
onboard
»
on the CP3004-HDD extension module
Only one battery may be installed at a time. Refer to Table 1 for battery requirements. The battery
should be replaced only with an identical or equivalent type recommended by the manufacturer.
