Kontron AM4904, User Manual

Page: 127 / 135

A-7 AM4904 User Guide
www.kontron.com
rm_watchdog_tick 500
Watchdog tick interval in ms. Note that this interval at which
other timeouts are checked (rm_master_timeout_ms,
rm_deviceid_timeout_ms, rm_xover_timeout_ms), thus it
should be less than these.
rm_watchdog_timeout 5000 Watchdog timeout value in ms.
rm_xover_timeout_ms 2600
After this timeout period, the backup will declare the xover
heartbeat to the active mch failed if it is enabled
rmcp_udp_port 623 UDP port number for RMCP
sel_reset_sel_pdata 0
0=normal operation, scan SEL on startup
1 = completely reset PDATA SEL flash storage to empty
srio_activate 0
0 = do not take S1302 / T3 out of reset if present, 1 = do
assume s1302 is installed, take S1302 / T3 out of reset and
execute init sequence
srio_always_reset 0
1 = always take SRIO into reset first, 0 = skip SRIO initializa-
tion if SRIO is not in reset
srio_init_early.N n/a
SRIO initialization sequence executed before T3 is taken out
of reset. There are a number of I2C initialization sequences
executed during startup and before the SRIO T3 is taken out
of reset. srio_init_early.N contains CLI commands to be exe-
cuted during initialization. This can be mainly the I2C com-
mands.
srio_init_late.N n/a
SRIO initialization sequence executed after T3 is taken out of
reset. There are a number of I2C initialization sequences exe-
cuted during startup and after the SRIO T3 is taken out of
reset. srio_init_late.N contains CLI commands to be exe-
cuted during initialization. This can be mainly the I2C com-
mands.
srio_link_mode.N 0
Controls SRIO link state of Fabric DEFG Port ID N
0 = use ekeying to enable or disable link
1 = force link to be enabled
2 = force link to be disabled
srio_reset_delay_ms 200 Delay in ms after SRIO T3 tongue is taken out of reset.
startup_active.N n/a
Standard CLI initialization sequence executed when CM is
starting as active carrier manager. startup_active.N contains
CLI commands to be executed during initialization.
startup_inactive.N n/a
Standard CLI initialization sequence executed when CM is
starting as inactive/backup carrier manager.
startup_inactive.N contains CLI commands to be executed
during initialization.
om6060_slot_cnt 6
Limit number of supported slots for OM6060 compatible
backplanes
fan_local
Enable support for a fan controller on the backplane.
“MB04D-101” sets fan controller support for this backplane
Table A-1: CM configuration file settings (Continued)
Setting Default Description