NetBootLoader
AM4100
Page 5 - 32
ID 36126, Rev. 2.0
P R E L I M I N A R Y
DESCRIPTION:
To set or display the parameters of an Ethernet port the command
NET is used.
Initially the AM4100 does not have any valid Ethernet port
configurations, therefore, these interfaces are inoperable. The initial
configuration of the Ethernet ports must be done from the SER0
interface using the command “net ... -f”.
Using the “-f” option forces a CRC to be performed and stored along
with the other configuration parameters in the serial EEPROM.
Once the configuration of an Ethernet port is done, it is available for
operation. Later changes to the parameters do not require the use of
the “-f” option to force a CRC. This is done automatically.
The <ip-addr> parameter must be set to 255.255.255.255 if the
DHCP command is to be used for the configuration of the Ethernet
interface.
If the NET command is issued without any parameters, the current
parameter settings of all the Ethernet ports is displayed.
N E T
Summary of Contents for AM4100
Page 19: ...AM4100 Introduction ID 36126 Rev 2 0 Page 1 1 Introduction Chapter 1 1 P R E L I M I N A R Y...
Page 57: ...AM4100 Installation ID 36126 Rev 2 0 Page 3 1 Installation Chapter 1 3 P R E L I M I N A R Y...
Page 65: ...AM4100 Configuration ID 36126 Rev 2 0 Page 4 1 Configuration Chapter 1 4 P R E L I M I N A R Y...
Page 89: ...AM4100 NetBootLoader ID 36126 Rev 2 0 Page 5 1 NetBootLoader Chapter 1 5 P R E L I M I N A R Y...
