AM4100
Configuration
ID 36126, Rev. 2.0
Page 4 - 3
P R E L I M I N A R Y
4.
Configuration
4.1
Configuration of DIP Switches
4.1.1
SW2 DIP Switch Configuration
The General Purpose DIP switch, SW2, consists of four switches for board configuration:
switch 1 for POST code or User-Specific LED configuration, switch 2 for NetBootLoader (NBL)
Firmware Flash configuration, and switch 4 for configuring the low-memory address offset
mode of the e600 core 1. Switch 3 is reserved for future use.
Figure 4-1: SW2 DIP Switch
The following table indicates the functions of the four switches integrated in the SW2 DIP
switch.
Table 4-1:
SW2 DIP Switch Functions
SWITCH
FUNCTION
DEFAULT
1
POST code or user-specific LED configuration
OFF
2
NetBootLoader Firmware Flash selection
OFF
3
Reserved
OFF
4
Core 1 LM Address Offset mode configuration
OFF
Summary of Contents for AM4100
Page 19: ...AM4100 Introduction ID 36126 Rev 2 0 Page 1 1 Introduction Chapter 1 1 P R E L I M I N A R Y...
Page 57: ...AM4100 Installation ID 36126 Rev 2 0 Page 3 1 Installation Chapter 1 3 P R E L I M I N A R Y...
Page 65: ...AM4100 Configuration ID 36126 Rev 2 0 Page 4 1 Configuration Chapter 1 4 P R E L I M I N A R Y...
Page 89: ...AM4100 NetBootLoader ID 36126 Rev 2 0 Page 5 1 NetBootLoader Chapter 1 5 P R E L I M I N A R Y...
