Kontron AM4100, User Manual

Page: 27 / 150

AM4100 Introduction
ID 36126, Rev. 2.0 Page 1 - 9
P R E L I M I N A R Y
1.5 Technical Specification
Table 1-2: AM4100 Main Specifications
AM4100 SPECIFICATIONS
Processor and Memory
CPU The AM4100 supports the following microprocessors:
•
Freescale MPC8641D processor, 1.0 GHz, 400 MHz platform frequency
•
Freescale MPC8641D processor, 1.32 GHz, 528 MHz platform frequency
•
Freescale MPC8641D processor, 1.5 GHz, 600 MHz platform frequency
All microprocessors are provided in a 1023 FC-CBGA packaging.
Please contact Kontron for further information concerning the suitability of
other Freescale processors for use with the AM4100.
Memory Main Memory:
•
Up to 2 GB unbuffered DDR2 SDRAM memory with ECC running at 600 MHz
Cache structure:
•
64 kB L1 on-die full speed processor cache
•
32 kB for instruction cache for each core
•
32 kB for data cache for each core
•
1 MB L2 cache for each core
NetBootLoader (NBL) Flash Memory:
•
Two redundant Firmware NOR Flash chips (2 x 4 MB)
Mass Storage Device:
•
Up to 4 GB NAND Flash via an onboard IDE Flash Controller
Serial EEPROM with 64 kbit
AMC Interconnection
Gigabit Ethernet Common Options Region ports 0-1
•
Two Gigabit Ethernet SerDes ports
Front Panel
•
Two Gigabit Ethernet copper ports, or alternatively
Fat Pipes Region ports 8-9
•
Two Gigabit Ethernet SerDes ports (optional)
PCI Express or
Serial RapidIO Fat Pipes Region ports 4-7
•
One x4 PCI Express interface operating in root complex, or alternatively
•
One x4 Serial RapidIO interface operating in host or agent configuration
Debug Interface Extended Options Region port 14
•
Reserved for debug port
Serial Interface Extended Options Region port 15
•
One serial port
Clock Input Clocks
•
PCI Express clock reference input (FCLKA)
Connectors
Front Panel
Connectors
•
One serial port (SER0) with RS232-signal level on RJ45 connector
•
Two Gigabit Ethernet ports on RJ45 connectors
AMC Card-edge
Connector
•
One 170-pin AMC Card-edge connector
Switches
DIP Switches
•
One DIP switch consisting of four switches for board configuration, SW2
•
One DIP switch consisting of two switches for IPMI FRU data selection,
SW3