Konica Minolta IP-601, Instruction Manual, Page: 117 / 131

Print Controller INSTRUCTION MANUAL Appendix A-3
Appendix A Troubleshooting
■
General Problems of Printing
●
The Print Controller does not respond to the “Print” command.
1. Check that the printing system is selected as a current printer.
It is a requirement that the printing system is selected as a present printer on Windows
before printing.
2. Check that the power switch of the copier is turned on.
3. Print the “Test Page” from Windows.
When you can not print a job from a computer even though you can print a test print,
contact a system administrator or a service representative.
4. If a message “Controller HD Full” is displayed, see page Appendix A-4.
5. Check that the control panel is not set up in scanner mode but in copy
mode.
●
A message requesting a paper size you do not use is displayed.
●
Cancel the job to change the paper size of “Page (Paper) Setup” dialog on
an application.
●
Touch and select the desired size displayed in the paper sizes area of the
control panel, then press the [START] button. The forced out will start.
Refer to “ Chapter 4 Control Panel Setup
■
Print Job
●
Forced output ” for forced
output.
●
You can not print the test print.
1. Check the LCD of the main body printer control panel.
When “Ready to copy” is displayed on the LCD, go to Step 3.
When a diagnostic message or an error message is displayed on the LCD, refer to the
operating manual of the main body printer (copier).
When the LCD is blank, go to Step 2.
2. Press the POWER SAVER ON/OFF on the control panel.
When the main body printer is used in the Power Save mode, press this switch to show
the LCD in the Display mode.
3. Try to make a copy.
When copying is available, go to Step 4.
4. Turn off the copier and restart it. Print the test print again after the print
controller is ready.
Contact your Konica service representative if you cannot print the test page after per-
forming the above procedures.