Kongskilde Z 455 H, Operator'S Manual

Page: 74 / 92

7 - MAINTENANCE
Storage
Pressure washing
Before you use pressure washing, clean the implement
with compressed air.
NOTE: Legislation in certain countries and good practice
requires special treatment of waste water through sed-
imentation and oil separation and controlled removal of
residues.
Avoid pressure washing at ambient temperatures below
10 °C ( 50 °F ) or when the implement is wet. Place the
implement in a heated workshop or dry barn for at least
24 h . Clean the implement only when fully dry.
NOTE: Be careful when you clean the implement with a
high pressure washing. Avoid to direct water jets on electric
equipment, bearings, seals, gearboxes, etcetera.
NOTE: Grease all grease fittings carefully after you clean
the implement to press possible water outside bearings.
When you use a high pressure washer:
• Keep a minimum distance of
25 cm ( 9.8 in ) between
the spray gun and the surface to be cleaned.
• Spray under an angle of minimum
25° (do not spray
straight at the implement).
• Maximum water temperature:
50 °C ( 122 °F ).
• Maximum water pressure:
80 bar ( 1160 psi ).
• Do not use chemicals.
NOTICE: On the cylinders, do NOT direct the stream of a
high pressure washer at the wiper seal. Water could come
through the rod guide and create corrosion. This corrosion
could generate pollution and seizing of the cylinder rod and
the rod guide.
7-16