Kongskilde Z 455 H, Operator'S Manual

Page: 25 / 92

2 - SAFETY INFORMATION
Stopping the implement safely
WARNING
Moving parts!
Some components may continue to run after
disengaging the drive systems.
Make sure
all drive systems are fully disengaged and all
movement has stopped before servicing the
machine.
Failure to comply could result in death or se-
rious injury.
W0002A
Always interrupt the operation of the implement before
you leave the tractor seat.
For safety's sake never leave the tractor cab without first
to disengage the Power Take-Off (PTO) shaft mechanism
and to stop the tractor engine. Furthermore, if you leave
the tractor unattended, always remove the ignition key.
Stop the tractor engine and the PTO shaft and wait until
the implement has completely stopped before you open
any of the safety guards. There are rotating parts un-
der the safety guards which may continue rotating after
the implement has been stopped. Look and listen for evi-
dence of rotating parts before you open any of the safety
guards.
Make sure to secure the tractor by means of the hand
brake and/or stop blocks if you need to stand between
the tractor and the implement.
When, due to exceptional circumstances, you would
decide to keep the tractor engine running after leaving
the tractor cab, then the following precautions must be
followed:
• Bring the tractor engine to low idle speed.
• Disengage all drive systems.
• Shift the tractor transmission into neutral.
• Apply the parking brake.
When you park the implement there are some operational
risks which may cause personal injury. Therefore, you
must:
• Make sure that the ground is firm and even during park-
ing.
• Make sure that tractor and implement cannot move.
• Always lower the implement to the ground.
• Stop the tractor engine and remove the ignition key.
• Use correct support or transport safety device when the
implement is parked. Make sure that the parking stand
is secured.
When you detach the implement from the tractor:
• Always detach the implement carefully and on a flat
surface to prevent damage.
• Make sure that nobody stands in front of the implement.
• Never allow anyone to stand between the tractor and
the implement.
• Never go under an unsupported implement.
2-9