22
Trouble Shooting
Remedy
Reduce the speed of the conveyor belt.
Increase the speed of the conveyor
belt.
Increase the speed of the conveyor
belt. Check, if the conveyor belt should
be tightened.
Call for expert assistance for replace
-
ment of the knives / check that the con-
veyor blower works correctly / empty
the container for cut down material.
Replace or tighten the belts.
Adjust the die cutter according to it's
manual.
Adjust the feeding roller.
The sheets must be fed into the
machine one by one.
Problems
The material is not lying
plane on the conveyor belt.
The conveyor belt cannot
feed the material into the
machine.
The conveyor belt cannot
feed the material into the
machine.
The hopper/pipe system is
clogged by material not cut
down.
The machine runs too
slowly.
The material is not lying
plane on the conveyor belt
of the MultiDicer (curled
up).
The feeding roller cannot
feed the material into the
machine.
The machine is blocked at
the inlet opening.
Cause
The conveyor belt is running too fast.
The material overlaps on the conveyor
belt.
The conveyor belt runs too slowly.
The knives are worn / the suction
capacity of the conveyor system is
too small / the pipe system is blocked,
where the cut down material is
delivered.
The belts are too worn or slack.
The die cutter is not correctly
adjusted.
The feeding roller is not correctly
adjusted for the material in question.
Too many sheets are fed into the
machine at a time.
Summary of Contents for MultiDicer KMD 12
Page 58: ...58 Dimensioned Sketch KMD 12 Dimensioned Sketch KMD 18 ...
Page 59: ...59 ...
