Kolpa Kolpa-san Series, Instructions For Installation And Use Manual

Page: 38 / 98

Bathtub masage systems page 37
ENGLISH www.kolpasan.eu
The built-in timer shuts down the pump after 20 minutes, unless it is shut down manually
or unless the water heating is on.

SWITCHING ON THE BLOWER - AIR MASSAGE
Press the key BLOWER for switching on the compressor. By pressing the same key
again the compressor is switched off.
The built in time meter switches off the compressor after 20 minutes if we don't switch it
off manually beforehand.
(BLOWER icon is lit when the compressor is switched on.)

SETTING THE WATER TEMPERATURE
Use the UP and DOWN keys for regulating the water temperature with constant pressing
of the keys until the temperature reaches the desired set temperature. The set water
temperature remains shown on the screen for 10 seconds afterwards and then the
temperature returns to the actual water temperature in the bathtub.
(The icon ´SET POINT´ shows the desired (set) water temperature and not the
one set at the moment.
You can set the water temperature in steps of 0,5°C from 15°C to 40°C (59
to 104°F).

SWITCHING ON THE AUTOMATIC WATER HEATER
When the wate
r temperature is 0,5°C (1°F) lower than the temperature set, the heater will
automatically switch on until the water temperature reaches (the set tempe 0,5°C).
(The icon HEATER is lit when the heater is switched on. And the icon pulses
when higher temperature is needed yet the heater is still not switched on.)
Your system is set on 'limitation of the maximal use' and the heater won't switch on if the
compressor is activated.
While the water heater is running or during the filtration cycle, the FIRST pump will also
be working. During this time, it will not be possible to turn off the FIRST pump by pressing
the WATER MASSAGE key.
Warning:
Your system comes with the factory setting of the function “maximum electricity
consumption limit” at 16A. If you turn on the air pump while both water pumps are
running, the heater will automatically shut down and the icon will blink.
The heater will automatically reactivate 5 minutes after turning off the air massage
function or after turning off the second water pump.