Kolpa Kolpa-san Series, Instructions For Installation And Use Manual

Page: 30 / 98

Bathtub masage systems page 29
ENGLISH www.kolpasan.eu
bathtub. For this function to work properly it must be activated AFTER ALL OF
THE WATER IS DRAINED from the bathtub
– the bathtub is empty. If the cycle
finishes while air jets are still under water, the water will again fill the jets, negating
the effect of the drying.
Massage bathtub is installed with a system that automaticaly drains the water from
the pipes and air jets on the bottom of the bathtub, every time the water is released
from the bathtub by turning the handle on the overflow, thus lifting the drain plug on
the bottom of the bathtub. Because of that, the use of the Blowing after function is
not needed to empty the water from the air jets, but it IS RECOMENDED for
hygiene purposes after every use of the massage bathtub.
OZONE function:
The function will be activated, if you press OZONE button. Function is indicated by
LED3 switched on and fixed (nothing will be displayed). The function can be
switched off by pressing again the OZONE button for 2 seconds (long press).
This function will ADD OZONE to the water through special water jets for foot
massage. These jets are allways releasing small amaunts OF AIR BUBBLES into
the water. When the OZONE function is active, those bubbles will contain OZONE,
but when it is NOT active, they will contain only normal air, without OZONE.
The OZONE function is active ONLY WHEN THE WHIRLPOOL PUMP IS
WORKING. This can be for the Whirlpool function or for the Heater function active.
When the Whirlpool pump is working, LED1 for Whirlpool is fixed.
This system can produce maximum 70mg of Ozone per hour. This is low enough
to be safe for using this function with small children.
WARNING: If you have health problems with respiratory system (breathing), or
have problems with breathing in high altitudes, please consult with your doctor
before using this function for massage purpuses. You can still use OZONE function
as a water desinfection tool, but only if YOU ARE NOT IN THE BATHTUB, when
this function is activated.
Functions of OZONE in the water:
-
Ozone is the most powerful oxidant for disinfecting water or sanitizing
surfaces.
-
Ozone can kill several pathogens very quickly and effectively: Hepatitis B
Surfface Antigen (HbsAg), Influenza A virus, PVI, Saliva bacteria E.coli ms2,
Ape rotavirus SA-H and human rotavirus type 2, HIV, Microplasma
Chlamydia, etc.
- Ozone (O
3
) decomposes into oxygen (O
2
= normal Air).
Ozone will function ONLY when the Whirlpool pump is active and working - LED1
and LED3 are on. Ozone will be working when the Whirlpool pump is functioning
as a Whirlpool massage and when the pump is working with the water Heater.
Ozone will NOT WORK when the Whirlpool pump is deactivated or in Whirlpool
interval mode. During that time LED5 will be blinking, indicating the Ozone function