Kolpa Kolpa-san Series, Instructions For Installation And Use Manual

Page: 28 / 98

Bathtub masage systems page 27
ENGLISH www.kolpasan.eu
If any Whirlpool or Air massage functions are activated. The display will show both
water temperature AND remaining time for the FIRST ACTIVATED massage
function (countdown from 20 minutes). Both displays will alternate in 10 second
intervals.
After the countdown, both Air and Whirlpool massage functions will STOP, even if
they were not started at the same time.
WATER LEVEL LOSS is valid if the level sensor detects no water, 2-3cm above
the water jets, for at least 7 seconds. WATER LEVEL PRESENCE is valid if the
level sensor detects water, 2-3cm above the water jets, for at least 7 seconds.
WARNING: For any button on the keypad to accept a command, the button
must be pressed for a minimum time of 0,3 second. If the press is shorter,
the command will not be accepted.
Whirlpool massage:
If there is no water level and you press WHIRLPOOL button the function will not be
activated, LED1 will blink (1 second on, 1 second off) and a message
»h2o«
will
be displayed.
If you press WHIRLPOOL button when you have enough water in the bathtub,
Whirlpool massage function is activated and LED1 is switched on. The function
can be switched off by pressing again the WHIRLPOOL button. It has an automatic
time-out after 20 minutes.
Whirlpool INTERVAL function:
If you PRESS AND HOLD the WHIRLPOOL button for 2 seconds (long press),
INTERVAL function is activated, LED1 will be BLINKING.
In interval function, the WHIRLPOOL massage activates for 40 seconds, then
deactivates for the next 20 seconds. This interval is repeated until the function is
deactivated or the 20 minute time-out is reached. The function can be switched off
by pressing again the WHIRLPOOL button (short press).
WARNING: When Water heater function is active, the Whirlpool pump will
automatically activate when water heating is needed. If needed the Whirlpool pump
can still be deactivated for 5 minutes (stand-by) by pressing the WHIRLPOOL
button. The pump will stop working after 2 seconds to allow the water heater to
cool down. The Pump will automatically resume heating after 5 minutes.
Air massage (blower):
For the Air massage to function, there must be enough water, approximately 2-3cm
ABOVE THE MASSAGE JETS.
If you press AIR button when you have enough water in the bathtub, Air massage
function is activated, LED2 and LED5 will start BLINKING on/off. This function can
be switched off by pressing again the AIR button. It has an automatic time-out after
20 minutes.