Kollmorgen Digital MMC Control, Hardware Manual

Page: 236 / 322

234 Kollmorgen - December 2011
MMC Smart Drive Hardware Manual
-
S200-DLS DRIVE
Drive I/O Port DC Outputs
Configuration
• 4 optically isolated 24V DC outputs
•
Active high
• Current sourcing only (current into load)
•
Short circuit and overload protected
Maximum current 50mA per output
Voltage range 24VDC +15%-10%
Time delay on for resis-
tive loads
50 µsec. max
Time delay off for resis-
tive loads
50 µsec. max
Leakage current in off
state
0.5 mA max
Digital Link In/Out Ports
“In” port
Sends and receives high speed data to and from connect-
ed MMC-SD’s “Out” port.
“Out” port
Sends and receives high speed data to and from connect-
ed MMC-SD’s “In” port.
Cable Type
Shielded, Straight Pinned, CAT5 or better (CAT5e, CAT6,
etc.)
Maximum Cable
Length
30 m (98.4 ft)
Conformity
CE Marked
Note: Only units Rev 1
or higher are CE
Marked.
Conforms to Low Voltage Directive 73/23/EEC (amended
by 93/68/EEC) and EMC Directive 89/336/EEC (amended
by 92/31/EEC and 93/68/EEC).
Conformance is in accordance with the following stan-
dards:
EN 50178 and EN61800-3
UL and C/UL Recog-
nized
E233454
RoHs The S200-DLS Drives are not RoHs compliant