Kohzu Precision RC-010, Manual

Page: 29 / 58

SC-021/RC-010 Introduction Manual /Practical Version
25
No. Display on LCD Functional description Default
27 ENC PRESCALE
Setting of zero clear position when high speed table is
used
0
28 ENC RND OFF 0-9
Setting of display valid digit number of displayed value
after angle conversion
2
29 FEEDBACK TYPE 0-2
Setting of encoder correcting method
0: No correction 1: Correction only in positioning
2: Constant correction
0
30 PERMIT RANGE PULSE
Setting of allowable range pulse amount when encoder is
corrected
1
31 RETRY COUNT
Setting of retry number when encoder is corrected
100
32 WAIT TIME (1ms)
Setting of stop standby time before encoder is corrected
100
33 ENC ROTATE CHANGE
Setting of adding direction of encoder count
0
34 PM&ENC SYNC WRITE
Setting of encoder coordinate synchronization
0
35 SPD TABLE 1-300
Setting of speed table rewriting
1
36 SYS Refresh!!
Execution of system initialization
0
37 Line-1 Edit Axis
Setting of axis No. on first line on LCD panel
1
38 Line-1 Edit P E
Setting of conversion display on first line
0: Pulse non converted display
1: Pulse converted display
2: Encoder non converted display
3: Encoder converted display
0
39 Line-2 Edit Axis
Setting of axis No. on second line on LCD panel
2
40 Line-2 Edit P E
Setting of conversion display on second line
0: Pulse non converted display
1: Pulse converted display
2: Encoder non converted display
3: Encoder converted display
0
41 Manual Hi Speed
Speed table No.
Set by “ SET ” button at scan mode operation
7
42 Manual Lo Speed
Speed table No.
Set by “ CLR ” button at scan mode operation
1
43 Scan Pulse Val
Setting of pulse value driven by pressing just one time at
scan mode operation
1