SC-021/RC-010 Introduction Manual/ Basic Version
10
《
Origin Return Operation
》
ORG
Md PE Ax Sp
Val
O P 1 0
0
P 2 0
0
Md PE Ax Sp
Val
O P 1 0 L # # # # # # # #
P
2
0
0
When either a CW or CCW limit is triggered, an “L” will automatically appear in display.
Dual axis, origin return
1
st
axis, origin return
Dual axis, origin return
2
nd
axis, origin return
Stop
1
st
axis, origin return
2
nd
axis, origin return
Dual axis, origin return
Dual axis, origin return
To stop drive, press the same key or the “ESC” button.
1-2.
Performing
a
Manual Origin Return
Note: Operator has the option of using the Default Scan Mode Speeds, explained on page 9 of Section
1-1, or setting own default speed values, explained on page 11 of this section.
To start drive, press
one of the directional keys on the keypad (see diagram below).
《
《
N
N
o
o
t
t
e
e
》
》
The Origin Return Mode value is setting
No.3 (Norg + Org)
in the System Setting screen.
See pages
34 - 35
for additional information.
Switch to Origin Return mode at the Drive Setting Status screen by moving the dial-key up or down.
