Kohler Lombardini LDW FOCS 502 Euro 2, Service Manual

Page: 70 / 98

70
N
P
R
Q
A
B
C
E
D
104
105
106
7
Service Manual LDW FOCS 502 automotive _ cod. ED0053027270 - 3° ed_rev. 02
4. Slip on a new gasket ( P ).
5. Replace the falnge ( Q ) and put in the screws ( R ).
Important
• Be careful not to damage the sealing rings during this
operation.
6. Tighten the screws (
R
), in a crisscross pattern to a
final torque of 12Nm.
7.5.6 Installing the oil pump
Before installing the oil pump, make sure there are no
malfunctions (see “Check and overhaul the oil pump”).
Important
• Check that the contact surfaces are perfectly clean
and intact.
1. Slip on a new gasket (
A
).
2. Insert the oil pump activation key into the crankshaft.
3. Bring piston number one (flywheel side) to the top dead
centre, with the oil pump activation key in line with
break in the flange, in order to be able to assemble
the pump.
4. Install the pump ( B ) and put in the screws ( C ).
Important
• Be careful not to damage the sealing rings during this
operation.
oil pump activation
key
INSTALLATION OF ASSEMBLIES