Kohler Lombardini LDW FOCS 502 Euro 2, Service Manual

Page: 49 / 98

49
A
B
D
C
60
61
6
Service Manual LDW FOCS 502 automotive _ cod. ED0053027270 - 3° ed_rev. 02
6.2.9 Overhauling the decanting device
In order to overhaul the decanting device, it is necessary
to disassemble the starter motor.
See “Replacing the starter motor” for the correct
procedure.
1. Loosen the clamp and extract the pipe ( A ).
2. Remove the cover ( B ).
3. Thoroughly clean the inside of the cover and blow
compressed air on the decanting device ( C ) to
eliminate residues.
4. Check that the decanting device is intact and, if
necessary, replace it with an original spare.
5. Slip ona new gasket ( D ).
6. Replace the cover ( B ) and fix it using the screws.
7. Replace the pipe (
A
) and fasten it using the clamp.
8. Mount the starter motor and tighten the screws to a
torque 45 Nm.
6.3 OVERHAUL OF CYLINDER HEAD AND RELATED COMPONENTS
6.3.1 Checking and overhauling the cylinder head
1. Place the cylinder head on a surface plate and position
it with the corners on the stud bolts.
2. Using a dial indicator make sure the cylinder head is
level.
Important
• If the level deviation is above 0.1mm, the cylinder head
must be ground, removing not more than 0.2mm.
3. Before grinding, remove the valves (see “Disassembling
the valves”) and the precombustion chambers (see
“Disassembling the precombustion chamber”).
OVERHAULS AND TUNING