Kohler COMMAND CH18, Service Manual

Page: 215 / 232

11.17
Section 11
Reassembly
11
Figure 11-58. Installing Screws (Locations 3 and 4).
7. Install the inner baffles using the two remaining
hex flange screws (see Figures 11-59 and 11-60)
and finger tighten.
Do not torque the screws at
this time; they will be tightened after the blower
housing and outer baffles are installed.
Figure 11-59. Installing Inner Baffles.
Figure 11-60. Finger Tighten Two Remaining Cover
Screws.
Install Blower Housing and Outer Baffles
NOTE: Do not completely tighten screws until all
items are installed to allow shifting for hole
alignment.
1. Connect the plug to the key switch in the blower
housing (if so equipped).
2. Slide the blower housing into position over the
front edge of the inner baffles. See Figure 11-61.
Start a few of the screws to hold it in place. On
two-barrel carburetor models, lift the debris
shield up above the mounting surface, as the
blower housing is installed. Make sure the
ground lead, fuel solenoid lead, and oil pressure
switch leads are accessible and in proper
position. See Figures 11-61 and 11-62.
Figure 11-61. Installing Blower Housing.
Figure 11-62. Routing Wiring Harness and Leads
(Two-Barrel Models).
Debris Shield