Kohler COMMAND CH18, Service Manual

Page: 173 / 232

9.9
Section 9
Disassembly
9
Figure 9-33. Removing the Spark Advance Module
(Applicable Models).
4. Remove the three (each side) hex flange screws
securing the outer baffles. Note the location of
any lifting strap and position of the two short
screws (one each side on bottom) for reassembly.
See Figure 9-34.
Figure 9-35. Removing Outer Baffles.
5. Remove the outer baffles on both sides. See
Figure 9-35.
6. On engines equipped with a metal grass screen,
remove the screen before removing the blower
housing. See Figure 9-36. Plastic grass screens
can be removed after the blower housing is
removed.
Figure 9-34. Note Location of Two Short Screws.
Figure 9-36. Removing Metal Grass Screen.
7. Remove the lower blower housing screw and
washer securing the rectifier-regulator ground
lead or grounding strap.
8. Two-Barrel Carburetor Models Only: Remove
the two screws securing the debris shield to the
blower housing. The wiring harness is attached
to the underside of shield. See Figure 9-37.