Kohler COMMAND CH18, Service Manual

Page: 170 / 232

9.6
Section 9
Disassembly
Figure 9-22. Rear Air Cleaner Bracket (Some
Models).
2. Mark the spring hole locations and disconnect
the spring from the governor lever. See Figure
9-23.
Figure 9-23. Disconnecting Spring from Bracket.
3. Remove the choke linkage from the choke
actuator lever and carburetor. See Figure 9-24.
Figure 9-24. Disconnecting Choke Linkage from
Actuator Lever.
Figure 9-21. Removing Control Bracket.
Figure 9-20. Mechanical Fuel Pump.
Remove Control Panel (If So Equipped)
1. Disconnect the Oil Sentry™ Indicator Light
wires.
2. Disconnect the choke control cable from the
control bracket.
3. Disconnect the throttle control cable or shaft.
4. Remove the panel from the blower housing.
Remove Throttle & Choke Controls
1. Remove the four hex flange screws securing the
control bracket and rear air cleaner bracket
(some models) to the cylinder heads. See Figures
9-21 and 9-22.