Chapter 4 CVS-841/851
Installation
another form of shielding.
(2) The display unit should be grounded to the hull as short as possible. We recommend using a wide
and heavy copper braid or plate to be connected to a grounding stud at the rear of the display unit.
(3) The power supply cable should be connected directly to the ship’s battery to avoid RF noise
conducted from other equipment on board.
4.6 Display Installation
The display unit is designed for table mount and flush mount. Refer to the following descriptions for
installation.
4.6.1 Table mounting
(1) Remove the two knurled fixing knobs that fix the display unit to the mounting bracket.
(2) Remove the display unit from the bracket and place it on a flat and safe area.
(3) Place the mounting bracket to the place where the display unit is to be installed, and fix the bracket
with four (4) tapping screws.
(4) Reset the display unit on to the bracket and fix it using the two screws that were removed in step
(1). Refer to the following figures for detail.
(4) Reset the display unit on to the bracket and fix it using the two screws that were removed in step
(1). Refer to the following figures for detail.
Figure 4.1 Fitting detail of CVS-841
[CVS-841]
Figure 4.1 Fitting detail of CVS-841
[CVS-841]
4-2
93132682-03
Display unit
Mounting bracket
Fixing screws
(M5 screw, 6 pcs)
Washer
Knurled fixing bolt
Unit in mm (inch)
