Antenna
®
Telescope
™
Antenna
®
Telescope
™
Installation Instructions
October 2018
7
Telescope Dual Table Bases without Beam
and Dual Utility Trays - Standard Electric
STEPS
PREPARE LEGS & CROSSBARS:
1. Attach (2) Horizontal Rail Cradles (C) to the
upper housing boxes on the Right Hand
and Left Hand Column Leg Assemblies
(A/B), with (2) 5/16-18 x 1 1/4" button head
hex machine screws (L) per cradle.
2. Attach a Housing Cover (E) to the short end
of each housing, using (2) 1/4-20 x 5/8” flat
head Phillips machine screws (M) per cover.
3. Attach a Transformer Shelf (F) to the opposite
side of each housing, using (2) 1/4-20 x 5/8” flat
head Phillips machine screws (M) per shelf.
Note:
Do not attempt to rotate the outer column
tube unless the column is moving either upward
or downward. If it is necessary to orient the
welded column bracket, you must first, temporarily
connect a power supply and handset. Then plug
the power supply to building power. Depress the
Up button to run the column upward, ONLY while
the column is running, rotate the outer column tube
to orient the bracket as shown in the above image.
Lower the column and disconnect the power
supply from the building power, then from the leg.
Exploded Table Base Without
Beam Assembly, Steps 1-3
Step 1
Step 3
Step 2
1/4-20 x 5/8” Flat
Head Phillips
Machine Screw (M)
Left Hand Column
Leg Assembly (B)
Right Hand Column
Leg Assembly (A)
Housing
Cover (E)
5/16-18 x 1 1/4"
Button Head Hex
Machine Screw (L)
Horizontal Rail
Cradle (C)
Transformer Shelf (F)
1/4-20 x 5/8” Flat
Head Phillips
Machine Screw (M)
