Antenna
®
Telescope
™
Antenna
®
Telescope
™
Installation Instructions
October 2018
49
Telescope Single Sided Table Bases with Beam
(with or without Utility Tray), Side by Side Application
Pattern Numbers Represented:
Telescope Single Sided Base, Height Adjustable Standard
Electric, with Beam Only, Left Hand,
YBTSSFESBNL_
Telescope Single Sided Base, Height Adjustable Standard
Electric, with Beam Only, Right Hand,
YBTSSFESBNR_
Telescope Single Sided Base, Height Adjustable Extended
Electric, with Beam Only, Left Hand,
YBTSSFEXBNL_
Telescope Single Sided Base, Height Adjustable Extended
Electric, with Beam Only, Right Hand,
YBTSSFEXBNR_
Telescope Single Sided Base, Height Adjustable Standard
Electric, with Beam and Tray, Left Hand,
YBTSSFESBTL_
Telescope Single Sided Base, Height Adjustable Standard
Electric, with Beam and Tray, Right Hand,
YBTSSFESBTR_
Telescope Single Sided Base, Height Adjustable Extended
Electric, with Beam and Tray, Left Hand,
YBTSSFEXBTL_
Telescope Single Sided Base, Height Adjustable Extended
Electric, with Beam and Tray, Right Hand,
YBTSSFEXBTR_
Supplemental Parts List:
[See the installation instructions for Telescope Single Sided
Table Bases with Beam (with or without Utility Tray), Stand-
Alone Application for a complete list of additional parts.]
¼-20 x .75" Button Head Machine Screw
(A)
¼
-20 x
¾
" Flat Head Phillips Machine Screw (B)
Dovetail Linking Brackets (C)
Wire Hanger (D)
Connector Link (E)
Tools Needed:
Power Drive
Phillips #2 and #3 Bits
5
/
32
",
3
/
16
", ¼" Hex Bit Sockets
Ratchet Torque Wrench (150 in-lb) for
3
/
16
" Hex Bit Socket
4mm Allen Wrench
Level (or Laser Level)
Rubber Mallet
(A) 7283140
(B) 7418440
(D) 3AF4090*
(C) 3AF4009*
(E) 3AF4010*
Steps:
NOTE:
These directions are to be used in
conjunction with the installation instructions
for Telescope Single Sided Table Bases with
Beam (with or without Utility Tray), Stand-Alone
Application. The instructions below only address
the modifications necessary to connect single
sided tables for a side by side application.
PREPARE TABLES FOR CONNECTION:
Please refer to instructions for Telescope Single
Sided Table Bases with Beam (with or without
Utility Tray), Stand-Alone Application, and complete
the following steps for each table to be connected.
Follow steps 1-5
to prepare legs and crossbars.
*NOTE VARIABLES FOR STEP 4:
There will be
different drilling patterns on the crossbars. Single
Sided Crossbars in an “end” location will have
holes on the inner side to accept the legs at front
and beam at back (and utility trays in center,
where specified). Single Sided Crossbars in a
“connected” location will have additional drillings
on the outer side to accept Connector Links.
Follow steps 6-8
to connect beam to crossbars.
Follow steps 9-10 to connect crossbars to legs.
Follow steps 11-14
to prepare & install back panel.
Follow steps 15-18
to install rails.
Follow steps 19-20
to install utility
trays (where applicable).
Follow steps 21-23
to level tables.
Follow steps 24-26
to install the height
adjustment electrical components.
Follow steps 27-28
to perform a reset for
the pair of columns in each station.