Antenna
®
Telescope
™
Antenna
®
Telescope
™
Installation Instructions
October 2018
84
Telescope End Panels for Single Sided Table
Continue as follows:
POSITION CONNECTOR LINKS:
1. Attach (2) Dovetail Linking Brackets (B) to the
outside of the crossbar at the “end panel”
location using (2)
¼
-20 x .75" flat head
machine screws (G) for each bracket. The
base of the “L” should be oriented downward.
2. Slide the (2) End Panel Connector Links (A)
down onto the linking brackets attached to
the crossbar. Do not fasten from below yet.
PREPARE END PANEL:
3
. Attach (3) Keyhole Plates (J) to the end panel
with (2) #5 x ¾ flat head wood screws (K)
per plate. Be sure to orient the keyhole plate
so that the screw head opening is towards
the bottom, and the slot is towards the top.
4. Attach (2) Dovetail Linking Brackets (B) to
the holes with threaded inserts holes in the
center of the end panel, using (2) ¼ -20 x .75"
Flat Head Machine Screws (G) per bracket.
5. Attach the End Panel Block (C) to the
holes with threaded inserts holes on the
bottom of the end panel, using (2) ¼-20
x 1.25" Flat Head Machine Screws (H).
6. Apply a strip of Polyurethane Grip
Tape (F) to the inside curved surface
of the End Panel Leg Brace (D/E).
Single Sided Base Assembly, Partially Exploded, Crossbar and Back
PAnel Preparation, Steps 1-2, 9 & 11
* Additional for Step 14
Steps 2 & 9
End Panel Connector Links (A)
10-24 x .35 Bushing (M)
#10-24 x
3
/
8
Zinc Flat HEad
Shoulder Screw (L)
*Note addition for Step 14:
Step 1
¼-20 x .75" Flat Head Machine Screw (G)
Dovetail Linking Bracket (B)
Step 11
¼-20 x .75" Flat Head
Machine Screw (G)