Antenna
®
Telescope
™
Antenna
®
Telescope
™
Installation Instructions
October 2018
46
Telescope Single Sided Table Bases with Beam
(with or without Utility Tray), Stand-Alone Application
INSTALL RAILS:
15. Install (4) Rail End Caps (S) onto the ends
of the rails using a rubber mallet.
16. Prepare the leg cradles for the rails by fastening
(2) Cradle Clamp Brackets (E) loosely to
each cradle (D) using (4) ¼-20 x
5
/
8
" flat head
Phillips machine screws (L) per cradle.
NOTE:
The cradle clamp brackets (E) are
ALWAYS to be placed in the outer position
in the cradle (D), and the end is to be flush
with the face of the housing cover (F)
17. Slide the ends of (2) rails into the cradles on a
crossbar assembly. Position the rails so that the
end cap (S) sticks out past the cradle by ¼".
NOTE:
The original Antenna install gauge is not
to be used to set Telescope rail positions.
18. Tighten the screws (L) in the cradle clamp
brackets (E). Slide the free ends of the rails
into the opposite crossbar assembly and
repeat the above tightening procedure.
Exploded Single Sided Table Base Assembly,
Steps 15-18: Rail Installation
Rails
Rail End Caps (S)
Cradle Clamp Brackets (E)
¼-20 x
5
/
8
" Flat Head
Phillips Machine Screw (L)
Horizontal Rail Cradle (D)
Note: Cradle Clamp Brackets
(E) in Outer Position