KNIGHT D-SERIES SERVO HOIST OPERATION MANUAL
SECTION 5
SOFTWARE
83
Step 37.
Press the “GO TO LIFT TRAVEL LIMITS” button on the LIFT LOAD CELL screen.
Figure 5-61
Lift Travel Limits screen: (Refer to Figure 5-61)
Row #1) The ‘CURRENT POSITION (IN)’ display shows the vertical height measurement of the hoist.
The zero position of the hoist is close to the bottom of the hoist. The height measurements
increase in magnitude as the hoist’s control handle move towards the ground.
The ‘LIFT MODE UPPER LIMIT (IN)’ is entered here. The “+” and “-“ buttons will
increase or decrease this value by 1” per button-press.
The upper ‘SET TO CURRENT POSITION’ button will set the Lift Mode Upper Limit of the
hoist to the Current Position of the hoist.
Row #2) The vertical ‘VISUALIZATION’ bar shows the available travel limits of the hoist in Green.
The ‘LIFT MODE LOWER LIMIT (IN)’ of the hoist is entered here. The “+” and “-“ buttons will
increase or decrease this value by 1” per button-press.
The lower ‘SET TO CURRENT POSITION’ button will set the Lift Mode Lower Limit of the
hoist to the Current Position of the hoist.
Row #3) The ‘RESET TO PHYSICAL LIMITS’ button will set the hoist’s Lift Travel Limits to the hoist’s
Physical Limits.
Buttons) Press the ‘GO TO LIFT LOAD CELL’ button to go to that screen.
Press the ‘GO TO LIFT SPEED LIMITS’ button to go to that screen.