KNIGHT D-SERIES SERVO HOIST OPERATION MANUAL
SECTION 5
SOFTWARE
74
Step 28.
Press the “REMOTE CONTROL” button on the MOTION INDEX screen.
Remote Control screen: (Refer to Figure 5-52)
Row #1) The ‘DIGITAL LIFT ENABLE’ button must be pressed for the Remote-Control functions to
operate.
Row #2) The ‘DIGITAL SLOW SPEED (IPS)’ display shows the command velocity for the slow jog
function.
The ‘DIGITAL FAST SPEED (IPS)’ display shows the command velocity for the fast jog
function.
Row #3) The ‘DIGITAL ACCELERATION (IPS^2)’ display shows the acceleration setpoint for digital
commanded velocity.
The ‘DIGITAL DECELERATION (IPS^2)’ display shows the deceleration setpoint for digital
commanded velocity. This value should be set equal to or higher than the acceleration
setpoint for digital commanded velocity.
Row #4) The ‘FLOAT MODE INACTIVE’ indicator will change to ‘FLOAT MODE ACTIVE’ when the
hoist is in Float Mode.
The ‘FLOAT’ button will cause the hoist to go into Float mode.
The ‘EXIT FLOAT’ will cause the hoist to go out of Float Mode.
Row #5) The ‘LIFT MOVE INACTIVE’ indicator will change to ‘LIFT MOVE ACTIVE’ when the hoist is
in Lift Mode.
The ‘LIFT BUTTON’ will cause the hoist to go into Lift mode.
The ‘EXIT LIFT’ will cause the hoist to go out of Lift Mode.
Figure 5-52
