Predeployment Test
3-13
3.8.2 SonarPro Workstation Controls and Indicators
Most of the SonarPro Workstation controls and indicators are on the SonarPro
Workstation front panel which is shown is Figure 3-7. Also shown is the location
of the DVDRW optical drive.
The SonarPro Workstation controls and indicators are the following:
ON/OFF switch:
Rocker switch/circuit breaker that switches AC
power to the SonarPro Workstation and provides AC
input current protection. This switch/circuit breaker,
which is on the back panel and is shown in
Figure 3-5 on page 3-9, should be left in the ON
position. Should the breaker trip, the switch/circuit
breaker will switch to the OFF position. To reset it,
switch it to the ON position.
HARD DRIVE ACTIVITY:
Green LED that flashes when the hard drive is being
accessed.
ETHERNET:
Green LED that flashes when there is activity on
Ethernet port.
POWER:
Blue LED that is on when the SonarPro Workstation
is on.
POWER switch:
Push button switch that turns the SonarPro
Workstation on or off.
RESET switch:
Push button switch that resets the SonarPro
Workstation.
3.9
Predeployment Test
To perform the predeployment test:
1.
Verify that the Sonar Head Unit has been properly set up and the system
components connected.
2.
Turn on the navigation system and let it acquire its location.
3.
Verify that the deck cable is connected to the Sonar Head Unit and to the TPU.
4.
Turn on the SonarPro Workstation and wait for the Windows desktop to appear.
5.
Turn on the TPU.
The SYS READY indicator should flash. Then after approximately 1 minute,
the T/F POWER indicator should turn on, the SYS READY indicator should
stop flashing and remain on, and the STATUS TRIGGER indicator should
begin flashing at the ping rate of the sonar.
Summary of Contents for HydroChart 5000
